ProtectGuard Plant Based
Product description
WATER AND OIL REPELLENT, ANTI-STAINING SEALER
BIOSOURCED FORMULA, PLANT-BASED INGREDIENTS
ProtectGuard® Plant-Based Formula is a new generation product for the water-repellent, oil-repellent and anti-stain protection of all porous and low-porous building materials.
ProtectGuard® Plant-Based Formula is a bio-based product derived from biomass. It has been formulated with ingredients of plant origin (corn, beetroot, tree resin). The use of plant molecules represents an eco-responsible alternative to fossil resources that are harmful to theenvironment.
ProtectGuard® Plant-Based Formula durably protects all materials and helps prevent the main causes of degradation such as stains, atmospheric pollution, greasy soiling, infiltration... It delays the aging of the support and facilitates its maintenance.
ProtectGuard® Plant-Based Formula also has a non-slip property that limits the slippage of the material. ProtectGuard® Plant-Based Formula lets the material breathe. The support thus remains permeable to air and water vapor. Colorless after application, it does not modify
the nature of the treated support. In addition, it is perfectly UV resistant and does not discolor with age.
USE
ProtectGuard® Plant-Based Formula may be used indoors or outside on walls, floors. It is designed to protect all porous and low porous building materials such as natural and synthetic stone, concrete, terracotta, cement, selflocking paving, granite marble... On very low porous or polished materials, use ProtectGuard® MG.
HOW TO USE
Surface preparation :
• Apply the product to a surface that is clean, dust-free, grease-free and dry. To remove stains and
marks of pollution use Guard Wash® Express. In case of greasy stains use Net’Guard® Ultra
4 in 1. For efflorescence, laitance or concrete bloom use Guard Remover® Eco Efflorescence
& Cement.
• Rinse thoroughly until the surfaceiis completely
free from any cleaner marks and let dry 24 to
48 hours.
Application :
• Use neat, do not dilute.
• Shake the product well before use and always
carry out a preliminary test.
• Apply in one uniform coat. On very porous
materials, apply the product in two coats with
an interval of 15 minutes.
• Do not spray the product.
• On vertical surfaces, apply from the bottom-
up.
• Do not overload the support, apply a thin layer,
taking care to pull the product well.
• NOTE: in some cases, the product may leave
white marks on the surface after application.
This phenomenon is normal and the traces
disappear after complete drying.
• Drying time: 24 hours.
• Optimum effectiveness obtained after 7 days.
CONSUMPTION
- Porous materials: 5 to 7m² / L
- Low-poreus materials: 8 to 10m² / L